AH / AH(R) Heavy-duty slurry pump
Horizontal, end-suction, double-casing pump for strong abrasive slurries in mining, coal, metallurgy and power. Rubber (R) version for fine particles.
View detailsAll products
Browse by family below - every series shares one wear-parts philosophy.
Slurry PumpsGravel & Dredge PumpsVertical Sump PumpsFroth & Flotation PumpsFGD & Power Plant PumpsOilfield & Drilling Sand PumpsWear Parts & Spares
HH High-head slurry pump
Same layout as AH but with a larger volute and impeller for higher pressure; suited to long-distance transport and multi-stage series installation.
View details
G / GH Sand & gravel pump
Wide, unobstructed passage for large solids. Used in dredging, sand washing, dam desilting and coarse tailings.
View details
AF / AHF Froth pump
Purpose-built impeller and enlarged inlet to handle air-entrained froth without losing prime in flotation circuits.
View details
ZJ Heavy-duty slurry pump
Widely used in Chinese mineral processing plants; interchangeable wear parts, high chrome or rubber, with a reinforced bearing housing.
View details
ZGB High-head slurry pump
Two-stage hydraulic design in a single casing for high-pressure tailings and long-distance pipeline transport.
View details
L Light-duty slurry pump
Compact, low-head pump for fine slurry, slime and light abrasive duties where a full heavy-duty casing is unnecessary.
View details
DT / TL FGD desulphurization pump
Corrosion-resistant pump for limestone and gypsum slurries in power-plant flue-gas desulphurization, in duplex stainless or high chrome.
View details
KWPK Non-clog centrifugal pump
Paper-stock and process pump with a non-clogging impeller, used for fibrous and high-consistency media.
View details
Magnum
The workhorse: centrifugal pump for drilling-fluid transfer, desanding and mud mixing. Sizes 3x2x13 through 10x8x14.
View details
Sandmaster
Designed for sand-laden fluid and solids-control service, with a heavy impeller and abrasion-resistant wetted parts.
View details
2500 Supreme
Higher-pressure casing for cementing, squeezing and mud-mixing duties where the standard Magnum runs out of head.
View details
Magnum XP
Extra-performance impeller and casing for frac sand blending and high-volume transfer, up to 14x12x22.
View details
Impellers
Closed and open designs, 3 to 5 vanes, in A05 high chrome or rubber-covered. Balanced before dispatch.
View details
Liners & throat bushes
Suction and discharge side liners, volute liners and throat bushes for AH, HH, G, ZJ and ZGB casings.
View details
Rubber parts
R55 natural rubber liners, impellers and cover plates for fine-particle and corrosive duties.
View details
Sealing components
Stuffing boxes, shaft sleeves, glands, lantern rings, expellers and mechanical seal cartridges.
View details
Bearing & drive parts
Bearing housings, shafts, bearing kits, baseplates, couplings and belt-drive components.
View details
SP / SPR Vertical sump pump
Cantilevered vertical spindle pump with no submerged bearing and no shaft seal. Metal (SP) or rubber-lined (SPR) wet end, column lengths built to the pit depth.
View detailsNeed a pump specification or a quote?
Send us your duty conditions and our engineers reply with a selection within 24 hours.